Hi,
i have a question about Direct acess. In my environment, i had two domain controllers, one with Server 2012 the other one with WS2012. I´ve enabled the DHCP-Role on Server 2008 R2 for Ipv4 and Ipv6. The IPv4 range was 192.168.80.X/24 and for IPv6 fec0::0/64.
The DA-Server is running a fresh installation of WS2012 and has a static IPv4 Address (192.168.80.75) and a static IPv6 address (fec::75), it is able to ping both DCs and ping all other servers in the same subnet, with IPv4/IPv6 addresses. They have two Network cards, one connected to the corporate network and the other one is directly connected to the internet (with two public ip addresses).
Then, i enable the Role RRAS on the fresh WS2012 and go to the Configuration Wizard. When I´m started the Getting Started Wizard and select Edge, there is a red cross on the left corner without a error message. So i used the Remote Access Setup Wizard.
On Step2, i selected Edge, notice the public name for the Server and go to Network Adapters, but the wizard show only the IPv4 Adress of the internal card. I activated the certificate of my CA-Infrastructure click next and reveice the following error message: Unhandled exception has occured in a component in your application. [...] An invalid IP-Adress was specified.
Please help me to resolve this error. Is the IPv6 address fec0:: not compatible with the Deployment of Direct Access?