I've got a server running server 2012 enterprise, one internal IP that is a NAT'd to a public IP address.
I've installed the Remote Access Direct Access roles and configured it and it was working. I am not using IPv6 internally, only IPv4. According to the server all services are up and running normally.
On my Windows 8 client - the GPO has been applied, and when connected directly to the LAN, the GET-DAConnectionStatus =ConnectedLocally.
The DA server shows the client connected, but I cannot get to any resources. I can ping to what I believe is the DA ipv6 address from the client and vice versa.
From the DA server, I cannot ping the DNS server address that is resolved in the configuration. fd6f:2e82:f50:3333::1, which is my DA server.
When I put in my actual DNS server of 192.168.100.1 in the configuration, the client goes to connected, but I cannot get to anything still.
I get a DNS error in the Operation Status of the server. I think put the IPv6 address of fd6f:2e82:f50:7777::c0a8:6401 on my DNS server and I can ping it from the client, but nothing else.
I cannot put IPv6 address on all my servers I need access to. I had this all working correctly before I moved to a different server hardware.
So I connect up to an external internet connection and the same command says Error: NameResolutionError.
Any ideas?