Hi there,
i have a few questions about IPv4 deployment of Direct Access, my current setup is already up and it works but i am not sure if everything is good:
DA Server has the following Network configuration
2 NIC NAT Setup
- one in the DMZ (nat to outside)
-> IPv6 is NOT configured, it is just activated
-> IPv4 is configured with Gateway but without DNS
-> Services like Client for MS Network are disabled
- one in internal LAN (direct)
-> IPv6 is NOT configured, it is just activated
-> IPv4 is configured without Gateway but with DNS
-> Services like client for MS Network are enabled
Now i am curious if i should set fixed IPv6 address on the Interfaces...should i? Does it matter?
Internally i see on the Client in the DCA logs thw following error
DTE-Liste
FEHLER - PING: fdc8:535f:5db8:1000::1
FEHLER - PING: fdc8:535f:5db8:1000::2
but internal detection works so far. Is this something that must be fixed?
Last question, the direct access setup DELETES the NLS address in DNS and gives an error about the missing dns record when i apply the config...my current workaround is to disallow write/deletion of this dns record for my admin account. But why happens this?
Thanks in advance.