Hi all, we have deployed NPS as a backup radius solution for our 802.1x project.
The design incorporates sending a vlan tag back to the switch, so each VLAN on the site has its own network policy to control that.
When I try to add in the IP addresses of the switches on one of the VLANs on the site, I actually am unable to add them all in. Does anyone know what the limitation of the Client IPv4 Address condition property is and if it is possible to increase it?
I have tried to figure out a way to do it with pattern matching, but the IP addresses are not in sequence so its a bit tricky to do.
I could also set up a second policy with the same setting, to cover the rest of the IP addresses but it would be nice to know the actual limitation so we can change our management scripts.
We put together a web frontend that allows us to configure NPS from a single location, but this kind of falls apart with this limitation.
Does anybody know?